Bringing Sensor Intelligence to Legacy Industrial Machines

By Contributed Article | November 17, 2026

Learn how sensor connectivity, motor monitoring, and vision inspection add capabilities to legacy industrial equipment.

Article Contributed By Abhishek Jadhav

Industrial machines often remain mechanically reliable for decades but, over time, provide very limited information about their current operating condition and performance. Operators may believe that production is continuing normally even when they lack sufficient information to detect developing equipment issues or declining performance.

Replacing legacy industrial equipment can be difficult to justify when the production process continues to operate effectively. Beyond the capital expenditure, replacement comes with downtime, installation, and commissioning before production can resume.

Brownfield modernization adds capabilities to existing industrial equipment and infrastructure. When appropriate automation technologies are implemented, engineers can address specific operational limitations while retaining valuable assets.

In the first part of this blog series on updating brownfield operations, we examine three practical retrofit approaches: connecting isolated machines, monitoring motors, and adding vision inspection to production lines. Other options include energy monitoring, human-machine interface (HMI) upgrades, and asset tracking, but these three practical approaches demonstrate how manufacturers can improve visibility into machine operation, equipment condition, and product quality.

Data access paths that fit existing infrastructure

Production counts can track output, but fault information explains why a cycle stopped. If the question is whether a shaft is rotating, a motor run command only shows that the controller requested movement. Each requirement calls for information that answers the question at the necessary update rate.

Choosing a data access method starts with understanding what the manufacturer needs to know about the machine.

Some of this information may already be stored in the programmable logic controller (PLC), machine controller, or installed instruments, even when the equipment is disconnected from plant information systems. Before using these values, engineers need to understand their source and what they represent. This includes verifying how a measurement is converted to engineering units and whether it updates frequently enough for the intended application.

A supported controller interface can provide this information, and a compatible gateway can provide access when the installed equipment uses an older interface. However, a gateway only makes existing data accessible. Additional sensing can help when the required measurement is unavailable.

The controller requires checking interface support, documentation, available communication capacity, and the polling frequency. Even read requests consume resources. Requesting information too frequently can affect controller performance. Engineers should acquire only the necessary information at a rate suited to the application.

Commissioning should confirm that measured values align with observed machine conditions. Other factors that influence the choice include installation costs, permitted network access, cybersecurity exposure, commissioning time, and recovery arrangements.

Engineers should choose the least intrusive access method that provides adequate information for the intended application.

Click here to read this article in its entirety on Mouser’s Automation Resource Center.

Visit Mouser to see sensors and other connectivity solutions for industrial automation.

Like this article? Check out our other articles on Automation, our Sensors/Antennas Market Page, and our 2026 Article Archive.

Subscribe to our weekly e-newsletters, follow us on LinkedIn, Twitter, and Facebook, and check out our eBook archives for more applicable, expert-informed connectivity content.

Contributed Article
Get the Latest News
x